Publicité
◾
When mounting the drive gear, the
surface of the gear stating "OUT"
should face toward the outside
(Fig. 21c).
5. Mount the wave washer and the
new wheel on the wheel axle. Note
that the round recess must face
outward.
6. Secure the wheel with the bolt by
tightening the bolt clockwise.
7. Mount the dust cover onto the wheel and press it in place.
REPLACING THE TRAILING
SHIELD (Fig. 22)
WARNING:
the battery pack when servicing or
transporting the mower.
WARNING:
mower unless the trailing shield is in
place and working. Never operate the
mower with damaged safety devices.
Failure to do so can result in personal injury. The trailing shield is subject to wear and
damage, which could expose moving parts or allow objects to be thrown. For safety
protection, frequently check the trailing shield and replace it immediately with only
identical replacement part listed in this manual.
1. Remove the battery.
2. Turn the mower on its side with the upper surface against the wall.
3. Use a Torx T20 screwdriver (not included) to loosen and remove the three locking
screws for the trailing shield; remove the worn trailing shield (Fig. 22).
4. Replace with a new trailing shield and attach it with the three locking screws.
56-VOLT LITHIUM-ION CORDLESS 22" LAWN MOWER — LM2230SP/LM2230SP-FC
Always remove
Never operate the
21c
22
Trailing Shield
Locking Screw
49
Publicité
