Publicité
7. Position the blade set onto the inner flange of the fan with the lower blade surface
marked "THIS SIDE FACING GRASS" facing toward the outside.
8. Align the plain washer with the motor shaft and assemble it in place.
9. Put the conical spring washer onto the shaft bolt with the convex surface facing
downwards, and mount the shaft bolt into the shaft and finger-tighten the bolt
CLOCKWISE (Fig. 18b).
10. Insert the metal rod (stabilizer 1) as
aid as shown in Fig. 18c.
11. Use the 9/16" (14 mm) torque
wrench to tighten the shaft bolt
CLOCKWISE. The recommended
torque for the blade set bolt is 36-
43 ft-lb (50-60 Nm).
NOTICE:
If the shaft bolt rotates with
the motor shaft when tightening the bolt,
place another small metal rod to act as
stabilizer 2.
56-VOLT LITHIUM-ION CORDLESS 22" LAWN MOWER — LM2230SP/LM2230SP-FC
18c
Stabilizer 2
High-lift Bagging
Blade Set
Stabilizer 1
43
Publicité
