Publicité
the heavy or lower end until the blade is balanced. It is balanced when neither
end drops (Fig. 20b).
6. Replace the blade on the mower and tighten it securely.
WARNING:
at high speeds. It may cause damage to the mower and could break, causing personal
injury.
LUBRICATING THE MOWER
All of the bearings in this product are lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions. Therefore, no further
bearing lubrication is required.
REPLACING THE WHEELS
(Fig. 21a, 21b & 21c)
WARNING:
the battery pack when servicing or
transporting the mower.
1. Turn the mower on its side with the
upper surface against a wall.
2. Use a flat-blade screwdriver (not
included) to pry the dust cover away
from the wheel.
3. Use an adjustable or 1/2"
(13mm) wrench to turn the bolt
counterclockwise to loosen it.
4. Remove the bolt, the worn wheel,
and the wave washer from the
wheel axle.
NOTE:
◾
When replacing the rear wheel, remove the drive gear from the worn wheel and
assemble it to the new wheel with the 3 screws using a Torx T20 screwdriver (not
included).
48
56-VOLT LITHIUM-ION CORDLESS 22" LAWN MOWER — LM2230SP/LM2230SP-FC
An unbalanced blade will cause excessive vibration when rotating
Always remove
21a
21b
Rear Wheel
Drive Gear
Wheel Axle
Dust Cover
Bolt
Round Recess
facing outside
Front Wheel
Wave Washer
Wheel Axle
Dust Cover
Bolt
Round Recess
facing outside
Screw
Publicité
