Vasco DX4 Manuel D'installation Et D'utilisation page 105

MOUNTING CO RF SWITCH
2
Always mount the CO
room whose CO concentration you wish to control. Always provide a 230 V
2
power supply at the switch.
Step 1:
Disassemble the
switch.
Step 4:
Connect the 230V
power supply to the
connectors.
MOUNTING RH RF SWITCH
Always mount the RH RF switch in an easily accessible location in
so-called "wet rooms".
Step 1:
Disassemble the
switch.
Step 2:
Mark out the screw
holes of the base
plate on the wall.
RF switch in an easily accessible location in the
2
Step 2:
Screw the base plate
firmly onto the wall.
Step 5:
Place the cover back
on the switch.
Step 3:
Screw the base plate
firmly onto the wall.
CONNECTION 0-10 V SIGNAL 19
Step 3:
Open the cover on the
base plate to reveal the
electrical connections.
Step 4:
Place the cover back
on the switch.