Publicité
TRANSMISSION GEARS LUBRICATION
EN
The transmission gears in the gear case need be
lubricated periodically with gear grease. Check the gear
case grease level about every 50 hours of operation by
removing the sealing screw on the side of the case.
If no grease can be seen on the flanks of the gear, follow
the steps below to fill with gear grease up to 3/4 capacity.
Do not completely fill the transmission gears.
1. Position the pole saw attachment on its side with
sealing screw facing upwards (Fig. Q).
2. Use the dual-head wrench provided to loosen and
remove the injection screw.
3. Use a grease syringe (not included) to inject some
grease into the screw hole; do not exceed 3/4 capacity.
4. Tighten the sealing screw after injection.
SPROCKET IN GUIDE BAR LUBRICATION
The guide bar has a sprocket at its tip. It must be
lubricated weekly with chain oil injected into the
lubricating hole by a grease syringe (not included) to
extend the guide bar life (Fig. R). Turn the guide bar and
check that the lubrication holes and chain groove are free
from impurities.
Fig. R parts description see below:
R-1 Lubricating Hole
R-2 Sprocket in Guide-bar Tip
TRANSPORTING AND STORING
1. Do not store or transport the pole saw attachment
when it is running. Always remove the battery pack
before storing or transporting.
2. Always place the guide bar sheath on the guide bar
and chain before storing or transporting the pole saw
attachment. Use caution to avoid the sharp teeth of
the chain.
3. Clean the pole saw thoroughly before storing.
Store the pole saw indoors, in a dry place that is
locked and/or inaccessible to children and keep
away from corrosive agents such as garden
chemicals and de-icing salts.
4. If the pole saw attachment is removed from the
power head and stored separately, fit the end cap
on the attachment shaft to avoid dirt getting into the
coupler.
14
POLE SAW ATTACHMENT — PSA1000
Protecting the environment
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for separate
collection. Electric machines must be
returned to an environmentally compatible
recycling facility.
Publicité
