Publicité
Running maintenance
Cleaning the machine
.
To clean the casing:
Use only soap and water.
To clean all the plastic components (control panel, plinth, etc.):
Use only a cloth dampened with water.
In all cases, do not use:
• Abrasive powders
• Metal or plastic sponges
• Alcohol-based products (alcohol, thinners, etc.)
Cleaning the products' box
Nettoyez régulièrement la boîte à produits. Pour cela :
- Press the bosses on each side of the box simultaneously to extract it
from its housing.
- Remove the siphons
from the rear of the box
box from its front cover
- Rinse everything under the tap (taking care to empty any excess water
remaining inside the box).
- Refit all the box' components, ensuring that the box section itself is
properly clipped into the cover and then re-insert the complete assembly
into its location under the machine's lid.
Frost risk
When there is a risk of frost, disconnect the water supply hose and empty
any water remaining in the drain hose by placing this as low as possible
in a basin.
Cleaning the filter
After a certain number of cycles, your machine will warn you that you
should clean the drain pump filter.
At the end of the cycle, the following two lights flash:
You must reset the cycle counter to remove this message: if you do not
do this, it will continue to be displayed at the end of every cycle.
Cleaning the pump filter
This filter catches any small objects inadvertently left in the clothes to
avoid their disrupting the pump's operation.
To clean the filter, proceed as follows:
- Open the drum doors. At the back of the drum, you will see a plastic
(Diagram D9 )
component
- Unlock this component (Diagram D10 ) .
To do this:
• Insert a rod (a pencil or a screwdriver, for instance) into the hole in
component
• While pressing down vertically with the rod, push component
towards the right until it releases from its housing
- Remove component
D8
H
(Diagram D8 ) .
and separate the
D9
K
D10
Care of the internal components
To ensure better hygiene, we recommend that you:
• Leave the lid open for a short time after washing.
• Clean the plastic and rubber access components to the tank approximately
once a month using a slightly chlorinated product. Run a rinsing cycle
to remove any residue of this product.
• Run a washing cycle at 90°C at least once a month.
Periodic checks
We recommend that you check the condition of the water supply and
drain hoses. If you notice the slightest cracking, do not hesitate to replace
them with identical hoses available from the manufacturer or his After-
Sales service.
Replacing a water supply hose
When replacing the hose, ensure that the hose is tightly fastened and
that there is a seal at both ends.
Replacing the power cable
For your safety's sake, this operation must be performed by the
manufacturer's After-Sales service or a qualified professional
electrician.
see diagrams
To reset the cycle counter when these lights are flashing, depress the
"Start / Pause" button "
If you do not clean the pump filter regularly, this can affect your
machine's performance.
- Turn the drum slightly towards the front of the machine with the doors
open (Diagram D11 ) .
Through the openings freed by removing component
access the pump filter
- Remove it from its housing (Diagram D11 ) .
- Remove the various objects that may be inside it.
- Rinse it under the tap (Diagram D12 ) .
- Re-insert it by pushing it fully into its housing, after checking that the
housing is clean.
- Re-insert component
the back of the drum and pushing it to the left until it is perfectly engaged.
(Diagram D13 ) .
D11
L
- 9 -
see diagram
D9-D10-D11-D12-D13
" until these lights go out.
.
, carefully positioning it in the openings at
D12
D13
D8
you can now
Publicité
