Publicité
Programming
Maintaining your washing machine's performance:
• When the 2 "
" lights flash at the end of a cycle, you must clean the pump filter
(see "CLEANING THE FILTER").
• After cleaning the filter, re-initialise the cycle counter by holding down the
2
"Start/Pause" button
until both lights are unlit.
For more details on the various functions, please refer to "DETAILS OF THE FUNCTIONS".
Please note: if you have stopped your machine by pressing the "On/Off" button or if there has been a power failure, when power is restored to
your machine, the washing cycle will restart automatically at the point at when the cycle was interrupted.
To select the most suitable programme for your type of washing, follow the instructions on the labels attached to most items.
Please refer to the meanings of the symbols at the end of this manual.
Programmes table
Type of textile
COTTON/WHITES/COLOUREDS
SYNTHETICS
DELICATES
WOOLLENS
HAND-WASHABLE TEXTILES
Special programmes
RINSE only
SPIN only
: These functions can be used alone or in combinations: no illogical combinations can be made.
Out of respect for your laundry, the machine prohibits the "Anti-creasing" and "Pre-wash" options being programmed simultaneously, because their
respective washing programmes are incompatible.
Programme ................................................................................
Load ....................................................................................................5 kg
To comply with the statement on the label, the tests are conducted in accordance with European Directive 92/75/EEC at nominal capacity, ensuring complete use of the CEI
detergent from the start of the washing phase.
Automatic safety systems
Lid opening safety system
As soon as washing commences, the lid on your machine is locked.
When the cycle is finished or when the machine has stopped with the
drum full of water, the lid unlocks.
If you have programmed a "Delayed start", the lid is not locked until
the waiting period is over and the cycle starts.
If you wish to open the lid during the cycle, press button
and wait 1-2 minutes for the safety system to unlock the lid.
Depending on when you wish to open the lid during the cycle, this time
delay may be a little longer because a cooling down period may also
have to be included.
In fact, to avoid your being severely burnt, the lid safety system will not
open during the cycle unless the temperature inside the machine is
below a certain threshold.
Temperature
STANDARD COMPARISON TESTING PROGRAMME
:
2
"
Max. load
Anti-
(°C)
(kg)
creasing
40°- 90°
5.0
30°- 60°
2.5
30°- 40°
1.0
- 40°
1.5
1.0
40°
2.5
Depending
on the fabric
- 60°
Duration ............................................................................................ 1 : 58
Energy. ......................................................................................0.95 kWh
Water ....................................................................................................42 l
Water safety system:
During operation, constant control of the water prevents any overflows.
Spin safety system:
Your washing machine is fitted with a safety system that restricts the
spin when poor load distribution is detected.
In this case, your washing may be insufficiently spun. Redistribute
" briefly
your washing in the drum and programme a new spin.
Anti-foam system:
You machine can detect when too much foam is being produced during
spinning.
At such times, spinning stops and the machine drains.
The cycle then restarts, adapting the spin rates and possibly adding
an extra rinse.
- 6 -
Lights
lights
permanently lit
+
flash
lights
permanently lit
Extra
Pre-wash
Drip-dry
rinse
Full drum
stop
Publicité
