Fujitsu SPARC Enterprise T5120 Notes De Produit page 65

Risque de déconnexion de la MCU suite à une
panne du module DIMM (CR 6656116)
Si le module DIMM tombe en panne, la MCU se trouve déconnectée et le message
suivant peut s'afficher sur la console.
Exemple :
Message
Jun 04 06:11:22: Chassis |major
initialization failed: DRAM init, disabled"
Jun 04 06:11:23: Fault
Jun 4 06:11:23 2008. /SYS/MB/CMP0/MCU2 Forced fail (DRAM init)"
Jun 04 06:11:24: Chassis |major
MB/CMP0/MCU3 unused because MB/CMP0/MCU2 is not configured"
Jun 04 06:11:24: Chassis |major
MB/CMP0/L2_BANK4, MB/CMP0/L2_BANK5 unused because MB/CMP0/MCU2 is
not configured"
Jun 04 06:11:24: Chassis |major
MB/CMP0/L2_BANK6, MB/CMP0/L2_BANK7 unused because MB/CMP0/MCU3 is
not configured"
Jun 04 06:11:24: Chassis |major
configuration: system operating at reduced capacity"
Jun 04 06:11:24: Chassis |major
DRAM Available: 002048 MB"
Commande showfaults
Last POST Run: Wed Jun 4 06:14:17 2008
Post Status: Passed all devices
ID FRU
1 /SYS/MB
fail (DRAM init)
Solution : identifiez et remplacez le module DIMM défectueux.
: "Jun
|critical: "SP detected fault at time Wed
: "Jun
: "Jun
: "Jun
: "Jun 4 06:11:24 ERROR: Degraded
: "Jun 4 06:11:24 ERROR: System
Fault
SP detected fault: /SYS/MB/CMP0/MCU2 Forced
Chapitre 2
4 06:11:22 ERROR: MCU2
4 06:11:24 ERROR:
4 06:11:24 ERROR:
4 06:11:24 ERROR:
Problèmes de dernière minute 57