Fujitsu SPARC Enterprise T5120 Notes De Produit page 38

Génération d'erreurs Ierrs lorsque le paramètre
100Mb/Full With Forced Speed/Duplex est défini
sur e1000g.conf (CR 6555486)
Des erreurs de type Ierrs peuvent être dues au paramètre ForcedSpeedDuplex.
La sortie de code suivante présente un exemple d'implémentation de la solution dans
le fichier
le duplex intégral 100 Mbits au moyen de la fonction d'autonégociation.
ForceSpeedDuplex=7,7,7,7,7,7,7,7,7,7,7,7,7,7,7,7;
for a typical instance.
# 7 will let adapter autonegotiate.
AutoNegAdvertised=8,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0;
will be
the
# Setting| N/A | N/A | 1000F |
# To advertise 10 Half only AutoNegAdvertised
30 Notes de produit des serveurs SPARC Enterprise T5120 et T5220 • Octobre 2008
. Dans cet exemple, le périphérique e1000g0 est configuré pour
e1000g.conf
# This will force Speed and Duplex for following settings
# 1 will set the 10 Mbps speed and Half Duplex mode.
# 2 will set the 10 Mbps speed and Full Duplex mode.
# 3 will set the 100 Mbps speed and half Duplex mode.
# 4 will set the 100 Mbps speed and Full Duplex mode.
# This parameter determines the speed/duplex options that
# advertised during auto-negotiation. This is a bitmap with
# following settings.
# Bit | 7 |
#
# For example:
# To advertise 10 Full only AutoNegAdvertised
# To advertise 10 Half/Full AutoNegAdvertised
# To advertise 100 Half only AutoNegAdvertised
# To advertise 100 Full only AutoNegAdvertised
# To advertise 100 Half/Full AutoNegAdvertised
# To advertise 1000 Full only AutoNegAdvertised = 32
# To advertise all speeds AutoNegAdvertised
6 | 5 | 4
N/A | 100F | 100H | 10F | 10H
| 3 | 2 | 1
= 1
= 2
= 3
= 4
= 8
= 12
= 47
| 0