Publicité
18 • SLEDGE
ADJUSTING THE ELECTRONIC SPEED CONTROL
Selecting Sport Mode
(Pro le #1: 100% Forward, 100% Brakes, 100% Reverse)
1. Connect two fully charged battery packs
to the VXL-6s and turn on your transmitter.
2. Press and hold the
EZ-Set button until the LED turns solid
green, then solid red and then begins
blinking red (indicating the Pro le
numbers).
3. When the LED blinks red once, release
the EZ-Set button.
4. The LED will blink and then turn solid green. The model is ready to
drive.
Selecting Race Mode
(Pro le #2: 100% Forward, 100% Brakes, No Reverse)
1. Connect two fully charged battery packs to the VXL-6s and turn on
your transmitter.
2. Press and hold the EZ-Set button until the
LED turns solid green, then solid red and
then begins blinking red (indicating the
Pro le numbers).
3. When the LED blinks red twice, release
the EZ-Set button.
4. The LED will blink and then turn solid
green. The model is ready to drive.
Selecting Training Mode
(Pro le #3: 50% Forward, 100% Brakes, 50% Reverse)
1. Connect two fully charged battery packs to the VXL-6s and turn on
your transmitter.
2. Press and hold the EZ-Set button until the LED turns solid green,
then solid red and then begins blinking
red (indicating the Pro le numbers).
3. When the LED blinks red three times,
release the EZ-Set button.
4. The LED will blink and then turn solid
green. The model is ready to drive.
Note: If you missed the mode you wanted,
keep the EZ-Set button pressed down and
the blink cycle will repeat until the button is
released and a mode is selected.
www.modellmarkt24.ch
Accessory Power Panel
The VXL-6s electronic speed control is equipped with
a power panel that can be used to power optional
A
B
accessories, such as LED light kits or additional cooling
fans (see Traxxas.com for additional information).
Always be sure to keep the panel cover installed when
Green to Red to O
One blink Red
accessories are not being used to protect the pins
C
D
from damage.
LED Codes and Protection Modes
The VXL-6s electronic speed control is equipped with sophisticated
Release
Solid
circuitry designed to help protect the electronics from damage caused
by overloading and excessive temperatures. When a protection circuit is
activated, an LED on the VXL-6s ESC will light, indicating a fault.
A
B
Green to Red to O
Two blinks Red
C
D
Release
Solid
A
B
Green to Red to O
Three blinks Red
C
D
Release
Solid
V
A A V
Explanation
Solution
Overcurrent
Stop driving; inspect the vehicle for
Protection,
overgearing or damage.
Stage 1
Overcurrent
Stop driving; inspect the vehicle for
Protection,
overgearing or damage.
Stage 2
Low Voltage
Stop driving; inspect the batteries and
Protection,
recharge.
Stage 1
Low Voltage
Stop driving; inspect the batteries and
Protection,
recharge.
Stage 2
Stop driving and disconnect the
Overvoltage
batteries. Inspect the batteries and
con rm the battery voltage.
Thermal
Stop driving; inspect the cooling fan
Shutdown
on the ESC. Allow the power system to
Protection,
cool before continuing.
Stage 1
Thermal
Stop driving; inspect the cooling fan
Shutdown
on the ESC. Allow the power system to
Protection,
cool before continuing.
Stage 2
Critical
functioning
Contact Traxxas Customer Service.
error
Programming
Contact Traxxas Customer Service.
error
Publicité
