WORMS JARD12OHV Manuel D'utilisation page 42

□ Do not fully pull the rope out and do not suddenly release it. Handle it gently until it is reeled in.
•
If the engine does not start, although you have tried several times, start above operations but first
put the CHOKE LEVER to CHOKE (CLOSED) position. [Fig. 22 or 23]
NOTE
If the engine does not start, although you have tried several times, contact your WORMS
ENTREPRISES dealer or the closest After Sales Service.
RATED SPEED:
Once the engine has started:
1. Let the engine run, idle, for 3 minutes;
2. Put the CHOKE LEVER to RUN (OPEN) position [Fig. 25 or 26];
3. For self-priming, place speed control to fast position. [Fig. 27 or 28];
4. Adjust the pump flow using the accelerator lever..
NOTE
The flow of the pump is controlled by adjusting the engine speed. The flow rate is increased by
moving the speed control to fast position. The flow rate is reduced by moving the speed control
to idle position.
NOTE
To save fuel and prolonge the lifespan of the pump, use the CHOKE LEVER to CHOKE (CLOSE)
position only when it is required.
RECOMMENDATIONS DURING OPERATION
□ Do not crush the suction and discharge pipes.
□ Protect the suction and discharge hoses from possible vehicle passages and avoiding to trample
the suction and discharge hoses. [Fig. 47]
42
WARNING
WARNING