Publicité
The doors will not close completely
Check the following:
•
Are food packages blocking the door open?
•
Are all bins and shelves pushed back into the correct
positions?
The doors are difficult to open
Explosion Hazard
Use nonflammable
cleaner.
Failure to do so can result in death, explosion,
or fire.
•
Are the gaskets dirty or sticky? Clean gaskets with mild
soap and warm water.
•
Has the door been opened and closed within the last few
seconds?
Wait at least 30 seconds to reopen the doors.
Temperature
is too warm
Check the following:
•
Are the air vents blocked in either compartment?
•
Are the door(s) opened often?
•
Has a large amount of food just been added to the
refrigerator or freezer?
•
Are the controls set correctly for the surrounding
conditions?
There is interior
moisture buildup
NOTE: Some moisture is normal.
•
Are the air vents blocked in the refrigerator?
•
Are the door(s) opened often?
•
Is the room humid?
•
Are the controls set correctly for the surrounding
conditions?
•
Was an automatic self-defrost
cycle completed?
Items in meat pan/crisper
are freezing
The temperature
inside the meat pan/crisper
may become too
cold, especially when using some additional control panel
features. Adjust the meat pan control to the closed setting.
The ice maker is not producing
ice or not enough ice
•
Is the ice maker wire shutoff arm or switch (depending on
models) in the OFF position?
•
Is the water line shutoff valve to the refrigerator turned on?
•
Has the ice maker just been installed? Is the freezer
temperature
cold enough to produce ice? Wait 24 hours
after ice maker hookup for ice production to begin. Allow
3 days after ice production
begins to completely fill ice
container.
Does the ice maker mold have water in it or has no ice
been produced?
Make sure your refrigerator has been
connected to a water supply and the supply shutoff valve is
turned on.
•
Has a large amount of ice just been removed? Allow
24 hours for ice maker to produce more ice.
•
Is there a water filter installed
on the refrigerator?
The
filter may be clogged or installed incorrectly.
•
Is an ice cube jammed
in the ice maker ejector arm?
For models with an interior ice bin, remove the ice from the
ejector arm with a plastic utensil.
•
Is a reverse osmosis
water filtration
system connected
to
your cold water supply?
See "Water Supply Requirements"
in the Installation Instructions.
The ice cubes are hollow or small
This is an indication of low water pressure.
Check the following:
•
Is the water shutoff valve fully open?
•
Are there kinks in the water lines that could restrict water
flow?
•
If you are using a water filter, remove the filter and operate the
dispenser. If water flow increases, the filter is clogged or
incorrectly
installed.
•
Is a reverse osmosis water filtration system connected to
your cold water supply? See "Water Supply Requirements"
in the Installation Instructions.
•
If you still have questions regarding your water pressure, call
a licensed, qualified plumber.
8
Publicité
