Continuity Testing; Non-Contact Voltage Detection - Amprobe VPC-12 Mode D'emploi

Continuity Testing

Disconnect circuit power and discharge all high-voltage capacitors before
testing continuity. Short circuit=0-45kΩ
Short or 0-45kΩ Open > 85kΩ
Figure 5: Continuity testing
VolTect™ Non-contact Voltage Detection
Press and hold down "NCV" button while placing the tester near AC
voltages within the specified voltage range. The tester will continually beep
and vibrate while AC voltage is detected.
Figure 6: Checking for the presence of AC voltage
8