Publicité
V1.1
15. Slide an M10 washer over each of
four M10 x 65 bolts. Slide a bolt from
the outside through each of the jack
base's arms and through the support
bar. Slide an M10 washer onto each
bolt and secure with an M10 nut (Fig.
4).
16. Slide a bolt from the outside through
each of the swing arms and through
the support bar. Slide an M10 washer
onto each bolt and secure with an M10 nut (Fig. 4).
17.
Check that the support bar lifts smoothly. Adjust the nut's tightness to
avoid binding or shifting.
18. Lay the screw jack (#5) on the frame
with the piston next the bracket on
the frame's mid-cross beam.
19. Slide an M10 washer onto an M10 x
65 bolt. Prepare a second bolt in the
same way.
20. Align the piston bolt hole between
the brackets. Insert the M10 x 70
bolt through the brackets and the
piston (Fig. 5-2). Slide an M10 washer
onto the protruding bolt. Secure with
an M10 nut. Tighten with a wrench.
21. Lift the assembled lifting frame upward to align the jack base brackets
with the cylinder's connection point. You may need to place blocks under
the arms to stabilize the frame and free your hands.
Page 7
SNOWMOBILE LIFT
www.princessauto.com / 1-800-665-8685
9123837
FIGURE 4.
FIGURE 5.
Publicité
