Publicité
OPERATING INSTRUCTIONS
TURBO
This function is meant to be used to reach a low
temperature in the shortest amount of time. It sets
the appliance directly to COOL mode, sets the
temperature at 18 °C (64 °F), and sets the fan
speed to high.
Note: This function cannot be set in HEAT mode
To set this mode:
• Press the
button until the
flashes on the screen
• Press the
button again to confirm - the
symbol will stop flashing and display on
the screen to indicate the function is working
To cancel this mode:
• Press the
button until the
flashes on the screen
• Press the
button again to confirm -
the
symbol will stop flashing and will
disappear from the screen, indicating the
function is canceled
• You may also press the
buttons to cancel the TURBO function
symbol
symbol
,
or
21
FOLLOW ME
This function can ONLY be set from the remote
The remote serves as a remote thermostat, allowing
for the precise temperature control at its location.
To set this mode:
• Point the remote control towards the appliance
and press
• Then press
follow me symbol
• Press the
button again to confirm - the
symbol will stop flashing and will be
displayed on the screen to indicate the function
is active
• The remote will send a signal to the appliance in
20 minute intervals until the
• If the appliance does not receive a signal in a
25 minute period, the Follow Me function will be
exited
To cancel this mode:
• Press
, then press the
button until the
• Press the
button again to confirm - the
symbol will stop flashing and will be
disappear from the screen, indicating the
function is canceled
or
button until the
flashes on screen
is pressed again
or
symbol flashes on screen
Publicité
