Publicité
OPERATING INSTRUCTIONS
REMOTE CONTROL SET-UP
• Point the remote control at the receiver on the
appliance
• The remote control must be no more than 7
meters away from the appliance without any
obstacles between the two
• The remote must be handled with care, do not
drop it or expose it to direct sunlight or sources
of heat
• If the remote control does not work, please try to
take out the batteries, wait approx. 10 seconds,
then put then back in again
Inserting or Replacing Remote Batteries
• Remove the cover on the rear of the remove
control
• Insert two "AAA" 1.5 V batteries - ensure they
are in the correct position (see instructions inside
the battery compartment)
• Put the cover back on the remote control
Note:
• If you are replacing or disposing of the remote,
the batteries much be removed and discarded in
accordance with current legislation, as they are
harmful to the environment
• Do not mix old and new batteries
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries
OPERATING MODES REMOTELY
COOL Mode
To set this mode on the remote:
• Press the
button until the
appears
• Using the
target temperature, between 18 °C - 32 °C (64
°F - 90 °F), until the corresponding value is
displayed
• Select the required fan speed by pressing the
button until you reach the desired fan
speed: High, Low, Auto
FAN Mode
The air hose does not need to be attached in this
mode
To set this mode:
• Press the
button until the
appears
• Select the required fan speed by pressing the
button until you reach the desired fan
speed: High, Low
18
symbol
and
buttons, select the
symbol
Publicité
