Publicité
INSTALLATION INSTRUCTIONS
EXHAUST HOSE
When using the appliance in cool mode, the hot air
exchange of the condenser must be exhausted out
of the room completely
INSTALLATION
Position the unit on a flat floor and make sure there
is a minimum of 18" (45 cm) of clearance around
the unit
Remember to position the unit within the vicinity of a
single circuit outlet power source
1. Extend both sides of the hose
2. Screw the hose into the hose inlet
3. Screw the hose into the hose outlet
4. Install the hose inlet into the back of the unit
Slide into
5. Attach the hose outlet to the window slider kit,
then seal
Vertical
Window
Window slider
Horizontal
Window
Window slider
13
Publicité
