Publicité
12.2.2 Replacement
Unclip the plastic edges of the bag from the frame, remove the bag from the upper cover.
Insert the fabric bag into the upper cover, clip the plastic edges of the bag onto the frame.
12.3
Water Nozzle (Fig. 14)
The left side of the mower deck (17) is fitted with a water nozzle (14) for washing the deck.
▪
When using the water nozzle (14), the machine must be in the lowest height setting and
placed on the lawn. This ensures that the water remains under the deck during cleaning.
▪
Attach a hose to the nozzle (14).
▪
Turn on the water and start the engine.
▪
The rotations of the blades will ensure that the water will clean the underside of the deck.
12.4
Changing / draining the oil
12.4.1 Check Engine Oil Level (Fig. 15)
Check the engine oil level with the engine stopped and the mower.
Remove the oil cap (7), and wipe the dipstick clean.
▪
Insert the dipstick into the oil filler neck, but do not screw it in.
▪
Check the oil level shown on the dipstick. If near the lower, fill to the upper level with the
oil (SAE 10W40). Do not overfill.
▪
Screw in the oil cap (7) securely.
NOTICE: Running the engine with a low oil level will cause engine damage.
12.4.2 Change Engine Oil
Drain the used oil while the engine is warm. Warm oil drains quickly and completely.
▪
Wipe the oil filler area clean, then remove the oil filler cap/dipstick (7).
▪
Place a suitable container next to the mower to catch the used oil, then tilt the mower on
its right side. The used oil will drain through the filler neck. Allow the oil to drain
completely.
▪
Please dispose of used motor oil and the containers in a manner that is compatible with
the environment. We suggest you take it in a sealed container to your local recycling
center or service station for reclamation. Do not throw it in the trash, pour it on the ground,
or pour it down a drain.
▪
Fill with the recommended oil. Do not overfill. Allow a couple of minutes for the oil to settle
in the engine, then measure the oil level.
12.5
To clean air filter (Fig. 16)
NOTICE: Operating the engine without an air cleaner, or with a damaged air
cleaner, will allow dirt to enter the engine, causing rapid engine wear.
▪
Press down on the cover tab and remove the cover.
▪
Remove the filter from the air cleaner base..
▪
Inspect the filter and foam element, and replace it if damaged.
▪
Clean the filter by tapping it several times on a hard surface to remove dirt, or blow
compressed air through the air filter from the inside. Never try to brush off dirt; brushing
will force dirt into the fibers.
▪
Wipe dirt from the inside of the air cleaner base and cover, using a moist rag. Be careful to
prevent dirt from entering the air duct that leads to the carburetor.
▪
Reinstall the filter and cover.
12.6
Maintenance schedule
Copyright © 2023 VARO
POWEG63773X
P a g e
| 14
EN
www.varo.com
Publicité
