Getting Started - Zavor LUX EDGE Manuel D'utilisation

flow/distribution when pressure cooking or steaming foods. The handles
make for easy transporting of the rack.
NOTE: When cooking smaller sized foods, make sure they do not fall through
the grates on the rack.
13. Control Panel: The easy to use controls allow you to select the different
programs available with a touch of a finger. The panel is equipped with 4
icons that let you know which stage of the cooking process the multi-cooker
is at. Also, on the control panel you will find the HIGH and LOW indicator
lights which will blink while pressure or temperature is building. These three
lights will go solid once the unit has reached proper pressure or temperature.

Getting Started:

Read the safety instructions found in this manual before plugging in and
operating the unit. Before using the multi-cooker for the first time, follow
these steps:
1. Remove all packing materials and literature from within the ZAVOR LUX™
EDGE multi-Cooker. Lift out the removable cooking pot and remove any
pieces of paper from under it. Remove the plastic protection from the control
panel and any stickers from the lid or stainless steel housing.
2. Wash all removable parts in warm soapy water. Rinse and dry all parts
thoroughly. Wipe the stainless steel outer housing with a clean damp cloth.
NEVER submerge the stainless steel outer housing in water or any other
liquid. Only the removable cooking pot is dishwasher safe.
3. To clean the pressure regulator knob, gently push the pressure regulator
knob down and at the same time turn the pressure regulator knob
counterclockwise past STEAM to the CLEAN setting. Once the white dot on
CLEAN is aligned with the white dot on the base of the pressure regulator,
you can lift the pressure regulator up and out of the lid. Look through the
holes of the pressure regulator to make sure there is nothing obstructing,
and then clean the pressure regulator knob with warm soapy water, allowing
the water to run through the pressure regulator to remove all particles.
4. To put the pressure regulator back onto the lid, simply align the CLEAN
setting with the white dot on the base, gently push down on the pressure
regulator and turn the knob clockwise until it slides back into place.
5. Make sure the silicone gasket is seated properly inside the lid or else the
cooker will not function properly.
6. After thorough drying, place the removable cooking pot back into the multi-
cooker before cooking.
Before First Use
7