Mute Feature; Cleaning And Maintenance - Zavor LUX EDGE Manuel D'utilisation

Masquer les pouces Voir aussi pour LUX EDGE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Mute Feature

In the event that you would like to disable all the beeps from the multi-cooker,
you may do so by pressing and holding the + and - buttons simultaneously until
the display shows the word MUTE. All beeps, including button presses and unit
notification sounds, will be disabled for the duration of the use.
To unmute the multi-cooker, press and hold the + and - buttons simultaneously
until the display shows the word BEEP and the unit emits two beeps. This will
unmute all beeps.
NOTE: If you mute the multi-cooker and then unplug it after use, this will disable
the mute feature and the until will be unmuted at its next use

Cleaning and Maintenance

Do not wash any parts of the multi-cooker in the dishwasher except for the
removable cooking pot. Always wash the removable cooking pot thoroughly
after every use, or if it has not been used for an extended period of time.
1. Unplug the multi-cooker and let the unit cool before cleaning.
2. Remove the removable cooking pot and wash with warm soapy water or
in the dishwasher. Hand washing is always recommended. Rinse and dry
thoroughly.
3. Wipe the outer housing with a clean damp cloth and rinse the lid with warm
water and soap. Do not submerge the multi-cooker or the lid in water.
NOTE: To remove an odor from the inside part of the lid, clean it with water
and vinegar (1:1 ratio).
4. Remove the condensation reservoir by pulling it down. Wash with warm,
soapy water. Rinse and dry thoroughly. Replace by pushing it back into
place.
5. Carefully remove the y-shaped silicone gasket attachment by grasping the
center of the metal "Y" and pulling. Remove the silicone gasket from the
metal ring. Clean the silicone gasket with warm soapy water. Rinse and
dry thoroughly. Place the gasket back on the metal ring and then place the
Y-shaped attachment back onto the lid by placing the silicone center piece
back on the steel tip and pushing down.
NOTE: The silicone gasket must always be properly positioned on the
underside of the lid; otherwise the unit will not work. Check periodically to
make sure that it is clean, flexible, and not cracked or torn. (See "Getting
Started" section in this manual.)
37

Publicité

Table des Matières
loading

Table des Matières