Peg-Perego Viaggio 1 Duo-Fix TT Notice D'emploi page 27

• Never leave the child unattended in the car seat:
observe him/her even when he/she is sleeping.
• Never remove the child from the car seat while the
vehicle is in motion.
• Make sure that the car seat is not obstructed by any
moving parts of the vehicle's seat or by one of the
doors.
• Adjust the height and tension of the straps, ensuring
that they are snug to the child's body without being
too tight. Check that the harness is not twisted and
that the child does not release it.
• This car seat is not designed for extended periods of sleep.
• Do not leave the car seat in vehicles exposed to the
sun. Some parts might heat up and be harmful to the
delicate skin of the child – check before placing the
child in the seat.
• Do not use the car seat without its fabric covering,
which cannot be replaced with one not approved by
the manufacturer since it is an integral part of the car
seat and the safety system.
• Do not use the car seat without the protective padding
for the shoulder straps as they are an integral part of
the car seat and the safety system.
• If you are unsure of anything, contact the manufacturer
or the retailer of this car seat.
• Do not remove the adhesive and stitched labels as this
might mean the product is no longer compliant with
standards.
• Do not use the car seat if it shows signs of breakage
or missing parts, if it is second hand, or if it has been
subjected to violent stress in an accident, because it might
have suffered extremely dangerous structural damage.
• Do not modify the product.
• For any repairs, replacement parts or information on
the product, contact the post-sales assistance service.
The relevant information is provided on the last page
of this manual.
• The car seat should always be secured in the vehicle, even
when the child is not present. In the event of sudden
braking, it could injure the occupants of the vehicle.
• Do not use this car seat after five years from the date
of production indicated on the structure. The natural
ageing of the materials may mean that it is no longer
compliant with standards.
• Do not use accessories that are not approved by the
manufacturer or by the competent authorities.
Instructions for use
UNIVERSAL CATEGORY - Belted
Fastening with seat belts
1• Place the Viaggio 1 Duo-Fix TT car seat on the vehicle's
seat, facing in the normal direction of travel of the
vehicle, as shown in the figure. The car seat is equipped
with a protective base.
Do not remove it when fitting the car seat with the
safety belts.
2• To make it easier to pass the vehicle's safety belts
through the back of the car seat, it is necessary to
recline the seat to the lowest position by operating the
lever, as shown in the figure.
3• Pass the vehicle's safety belt between the frame and
the shell of the car seat.
4• The lap belt must pass through the low slots marked in
red. Fasten the belt, ensuring that it clicks into place.
5• The figure shows Viaggio 1 Duo-Fix TT fitted in a
vehicle.
6• Check that the lap belt has gone through the low slots
marked in red and tighten it (Fig. a).
7• To complete the securing procedure in a vehicle, use
the Steady Fix device. Open the clip and pass the
diagonal strap through it, ensuring that it is taut and
not twisted (Fig. b). Close the safety tab (Fig. c).
8• IMPORTANT: Take hold of the safety belt and pull
it upwards firmly to fit Viaggio 1 Duo-Fix TT more
closely to the seat of the vehicle (Fig. d).
Once the procedure is complete, it is possible to recline
the seat to the desired position (See Point 2).
Instructions
UNIVERSAL CATEGORY - Isofix & Top
Tether
Fastening with Isofix & Top Tether
9• Use the lever as shown in the figure to recline the seat
27