Oase Filtral UVC 700 Notice D'emploi page 4

- English -
Installation (cont.)
Filtral UVC 1200
Important:
● The unit can be used with the following:
○ With the nozzle set to create various fountain displays.
○ With the branch valve, allowing an additional water feature to be operated simultaneously with the fountain nozzle.
○ With an air pump to enrich the water with additional oxygen
● It is recommened to place the unit horizontally on the ground ensuring its stable position.
● Do not lift the unit by its power cord.
● The unit's filter foam, biomedia, UVC and pump are preinstalled in the filter housing.
For connecting the air pump (optional)
●
Air pump is not included.
● Follow the air pump's instructions for product assembly.
● OASE recommends using the AquaOxy air pump.
1. Pull the clamps on both sides of the bottom strainer casing (A)
to the side and lift off the top strainer casing (B).
2. Remove the top foam filter (C).
3. Inside the housing, connect the aeration stone (D) with a
section of the hose (E) to the air connector (F)
● Place the aeration stone (D) between the gravel bags (G).
● Ensure that the hose is not kinked.
● Connect the aeration pump to the air connector (F) outside of
the housing. Read the aeration pump documentation.
4. Place the foam filter (C) in the bottom strainer casing (A).
● Attach the top strainer casing (B) and press it onto the bottom
strainer casing (A) until the clamps engage in the bottom
strainer casing.
● Important: Lead the connection cable (H) through the cable
opening in the bottom strainer casing (A) and route the cable
such that pinching is avoided.
1.
2.
3.
D
G
AquaOxy
4.
C
A
H
B
A
C
E
F
B
A
4