Inspection And Maintenance - TLV QuickTrap FP32 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8. Inspection and Maintenance

Operational inspections should be performed at least twice per year, or as called for by trap
operating conditions. Steam trap failure may result in temperature drop in the equipment, poor
product quality or losses due to steam leakage.
CAUTION
Body, Cover
Gaskets
Screen
Disc
Disc Holder Ring
Air Vent Ring
Valve Seat Surface inside Cover
Disassembly / Reassembly (to reassemble, follow procedures in reverse)
Part & No.
Connector Bolt 7
Connector
Gaskets 5 and 6
Cap 16
Cover 8
Disc 9
Disc Holder
Ring 14
Air Vent Ring 13
Screen Holder 12
Screen Holder
Gasket 11
Screen 10
• Inspection, disassembly, maintenance and repairs should be done only by
trained maintenance personnel.
• Before attempting to open the trap, close the inlet and outlet isolating
valves and wait until the trap has cooled completely. Failure to do so may
result in burns.
• Be sure to use the proper components and NEVER attempt to modify the
product.
Parts Inspection Procedure
Check inside for damage, dirt, grease, oil film, rust or scale
Check for warping or damage
Check for clogging or corrosion damage
Check for damage or wear
Check for damage or wear
Check for damage or wear
Check for damage or wear
During Disassembly
Remove with a socket wrench
See separate instruction 8.1
Grip tightly by hand and lift
off
Remove with a socket wrench
Remove, being careful not to
scratch the lapped surface
Remove without bending
Remove without bending, as
it will not return to ist proper
shape
Remove with a socket wrench Coat threads with anti-seize, then tighten to
Remove gasket and clean
sealing surfaces
Remove without bending
During Reassembly
Coat threads with anti-seize, then tighten to
the proper torque (page 7)
See separate instruction 8.1
Being careful not to bend it, push down
until cap slides into place
Coat threads with anti-seize, then tighten to
the proper torque (page 7)
Set on valve seat with the seat surface (the
lapped side) facing down (toward the valve
seat)
Set on the air vent ring and make sure that
it does not sit on the valve seat surface
Reinsert without bending
the proper torque (page 7)
Replace with a new gasket, coat surfaces
with anti-seize
Reinsert without bending
― 10 ―

Publicité

Table des Matières
loading

Table des Matières