Publicité
Attach Monitor To Arm
1
Hold the monitor angled back and lower it
onto the arm. Fit the hook at the top of the
arm into the corresponding cutout in the
VESA Bracket.
2
Tilt the monitor back upright until the Quick
Release Tab (B) on the arm snaps into
position.
3
To remove the monitor, lift the Quick
Release Tab and pull the bottom of the
monitor away from the arm, then lift free of
the hook.
NOTE: If needed, adjust the tension screw (A) to
hold the monitor in position.
Weight Adjustment
Your monitor should move up and down easily and stay in place
once adjusted. If it is difficult to adjust or moves without assistance,
it is not properly balanced.
M2.1: Weight Range: 5.5-15.5 lbs. (2.5-7 kg)
1
Press the Upper Arm Link (A) downward until Adjustment
Screw (B) is visible.
2
If the arm rises up on it's own, the lift force is too high
and can be decreased by rotating the Adjustment Screw
counterclockwise (towards -) with a 4 mm hex key. If the arm
falls down with the weight of the monitor, the lift force is too
low and can be increased by turning the Adjustment Screw
clockwise (towards +).
3
The current counterbalance setting can be seen through the
counterbalance indicator (C) on top of the upper arm. This
information can be used to quickly set multiple arms to the
same level without needing the monitors to be installed.
CAUTION: Do not over tighten the screws as it can damage the
screw head or threads.
6
A
B
A
C
①
②
③
B
Publicité
