Publicité
Attach Arm To Base Stem
NOTE: Before adding each link, adjust the smart
stop (A) according to step 2. If using a 3 link
configuration, one of the links must be a 4" link. The link
installation order may need to be swapped so as to comply with
step 2.
1
Insert the angled link into the mount until release button
locks in place.
2
Insert the dynamic link into the angled link until the release
button locks in place.
3
To remove links, press the release button (B) and lift
upward near the joint.
Attach Vesa Bracket To Monitor
1
Separate the VESA cover from the VESA bracket.
2
Position the VESA Bracket over the mounting holes on the back of monitor with the
D-shaped cutouts in a vertical orientation. Attach using the 4 VESA screws provided.
3
Snap the VESA cover back in place.
NOTE: The VESA Bracket features 75mm and 100mm hole patterns. If you need to offset the
Bracket from the monitor use the provided Extended VESA Screws and Plastic Spacers. You
may also use the screws that came with your monitor.
②
A
④
①
A
③
B
5
Publicité
