Publicité
OPERATING INSTRUCTIONS
PRIMING THE EASY-BREW ESPRESSO MACHINE
The unit must be primed before first use and after extended periods of disuse when the
unit goes completely dry. This will push water into the unit's internal parts and release
air from inside the pump. To prime, follow these steps:
Fill the water reservoir up to and not exceeding the MAX fill line.
1.
2. Place a heatproof cup or mug on the coaster set over the drip tray. Make sure the
steam control knob is set to OFF.
3. Plug in the unit and press the POWER button. The button will illuminate, and the
SINGLE-SHOT, DOUBLE-SHOT, and MANUAL coffee buttons will slowly pulse as
the unit heats. When heating is complete, the buttons will illuminate solid, indicating
they are ready for use.
4. Press the SINGLE-SHOT button. The unit will start pumping water through its
internal parts and a small amount of water should dispense into the cup. NOTE: The
unit may produce a loud noise when pumping water for the first time as the air is
released inside. This is normal and should stop after a few seconds.
5. Remove the cup from the drip tray and discard the water. The unit is now primed.
11
Publicité
