Publicité
5. Troubleshooting
5.1 TROUBLESHOOTING GUIDE
Problem
Possible reason
Power supply intrerupted.
No working
Power cord damaged
Running belt slips Running belt not tightened enough
Incorrect use of default
Remote control
Battery power shortage
does not work
Remote control maulfunction
Friction noise
Walking belt off center
In all cases of doubt, contact our customer service. You find the contact details on the last page.
6. Cleaning and maintenance
6.1 CLEANING
•
After each use, wipe sweat from the device with a slightly wetted cloth.
•
Never allow moisture or humidity to reach the computer or other electrical or electronic components.
•
Do not use abrasives or solvents.
6.2 MAINTENANCE
•
Before and after each training session, check that the device is in perfect condition. Also check that
all fastening parts and protective covers are in place and intact. Tighten bolts and nuts if necessary.
6.3 LUBRICATING
Lubricating under the running belt will ensure superior performance and extend its life expectancy.
After the first 25 hours of use (or 2-3 months) apply some lubricant, and repeat for every following 50
hours of use (or 5-8 months).
6.3.1 How to check running belt for proper lubrication
•
Remove the cap on the lubrication system,squeeze few drops of lubricant inside
•
If the surface is slick to the touch, then no further lubrication is required.
•
If the surface is dry to the touch, apply some lubricant.
Run on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
NOTE: DO NOT over lubricate running deck. Any excess lubricant that comes out should be wiped off.
Possible solution
Make sure that power cord is plugged
into properly grounded outled.
Replace new cable.
Tension the running belt
Replace new battery cells.
Replace new remote control
Adjust walking belt tension with the tool.
DE
EN
25
Publicité
