Maintenance - Tecno-gaz DAQF028 REV0.10 Mode D'emploi

TECNO-GAZ

9. MAINTENANCE

It is advisable to carry out a general check-up and to clean the appliance regularly, particularly if the supply water is very hard.
Particular attention should be paid to heating elemet and the bulbs of thermostats .
WARNING:
•
do not clean the machine outside with higt pressure water.
•
The protection class of the machine is IP 54.
•
Please contact the retailer that supplies your cleaning products for details of recommended methods and products for
sanitizing the machine regularly.
•
The machine has a safety thermostat that shuts down the power supply to the heating element and the tank in the event of
overheating.
To re-start the appliance the fault that caused overheating must be corrected.
Every 12 months:
- Clean the filters on the hot and cold water intakes and replace if necessary;
- Clean the diaphragms of solenoid valves and replace if necessary;
Clean the probe of termostat.
-
Even if the supply water is soft, the high working temperatures may cause limescale to build-up. Apart from damaging the resistors,
limescale can also clog the nozzles in which case the correct tank temperature for sterilization may not be reached.
WARNING: IT IS NECESSARY TO MAKE A MAINTENANCE AT REGULAR INTERVALS, THIS MEANS EVERY 3 MONTS, IN
ORDER TO GUARANTEE THE PERFECT FUNCTIONING OF PUMPS DOSING CHEMICAL PRODUCTS.
MEMBRANE PIPE INSIDE DOSING PUMP MUST BE CHANGED EVERY 12 MONTHS.
Cleaning the nozzles
•
Remove the washing rotors.
•
Unscrew and remove the 2 caps on each end of the washing arms in order to clean the inside.
•
Remove scaling.
Cleaning the external structure
•
Use mild detergents only, do not use abrasive detergents or solvents and/or thinners of any kind.
•
Your retailer can recommend suitable products.
Cleaning the control board
•
Clean the control board using a soft cloth dampened with a product specifically for plastic or a disinfectant specifically for this
type of use.
31
DAQF028_rev0.10