Control Panel And Symbols Used; Washing Programmes; Details Of The Electronic Front Card; Features Of Master Card - Tecno-gaz DAQF028 REV0.10 Mode D'emploi

TECNO-GAZ

4. CONTROL PANEL AND SYMBOLS USED

4.1 WASHING PROGRAMMES

SHORT PROGRAMME
STANDARD PROGRAMME
INTENSIVE PROGRAMME
4.2 DETAILS OF THE ELECTRONIC CARD
The electronic card was designed for the control of the type of machine described below.
Any use other than that specified above.
The electronic card was designed following the indications given in the standards below :
EN 60335
EN 50081-1 EN 50082-1
EN 55014
EN 55104
4.3 FEATURES OF MASTER CARD DIGITAL OUTPUTS
RL1: Controls the detergent measurer
RL3: Controls the cold water intake solenoid valve.
Allows cold water to enter the water tank. In rest conditions the relay contact is open, the valve is disengaged and therefore
closed.
RL4: Controls the discharge pump motor
RL5: Controls the washing pump motor
RL7: Controls the door locking coil
RL12: Controls the contactor of the heating elements
Process inputs
ID2 Tank level
ID5 Door closed
ID4 Door lock
ID3 Detergent level
P 1
Suitable for lightly soiled items.
Wash with detergent and thermal disinfection at 93°C for 1 minutes
P 2
Suitable for moderately soiled items.
Pre-wash, wash with detergent and thermal disinfection at 93°C for 3
minutes.
P 3
Suitable for heavily soiled items.
Intensive pre-wash, wash with detergent and thermal disinfection at 93°C
for 10 minutes.
low voltage
general
emissions
immunity
26
DAQF028_rev0.10