Control Panel - Tecno-gaz DAQF028 REV0.10 Mode D'emploi

TECNO-GAZ

4.4CONTROL PANEL

DISPLAY
•
Displays the various programmes, stages, temperatures and any machine faults.
•
During Wait, the type of programme selected is displayed.
•
After pressing Start, the first line indicates the temperature of the washing water for the entire cycle and the second line
indicates the various stages of the cycle.
•
In the event of a Shutdown, the first line indicates the shutdown status and the second line indicates the type of fault.
•
In the event of a Fault that does not cause the machine to shutdown (lack of detergent or limescale remover), the fault is
indicated in the second line during programme selection. If the detergent runs out when a 'with detergent' cycle is in progress,
the detergent finished message is given in second line of the display for the entire cycle.
Leds
•
There are 10 Leds:
•
a yellow Start led (1), a red Stop led (2), a flashing red led to indicate that disinfection did not take place (3), a green led to
indicate a complete cycle (4) and three yellow leds for indication of the various programme.
Buzzer
•
The buzzer sounds each time a key is pressed and intermittently in the case of a machine Shutdown.
4.5 SWITCHES
The 6 switches have the following functions:
P1
: Select "short" cycle.
P2
: Select "standard" cycle.
P3
: Select "intensive" cycle.
Start
Select the programme required and press the relative switch to start the cycle. At the end of the cycle, after the various stages. .
Stop
This switch interrupts the cycle in progress, the card interrupts the process, the red led indicating that disinfection did not take place.
Pushing start switch for restarting the cicle. Pushing Stop switch for interrupted the cycle, the door is unlocked.
PRG
Keep pressed for five seconds during Wait or Shutdown to display the Menu.
Operations, to enter into phases for programming, setting, time regulation and printing , are as follows:
KEYS SEQUENCE TO ENTER INTO "PARAMETER MENU":
ACTION
Press PRG for 5 seconds
Press -START-
Press -P 1-
Press –START-
KEYS SEQUENCE FOR TIME REGULATION:
Press -PRG- for 5 seconds
Press -PRG-
Press -START-
Press –START-
Pres –START-
Press –START-
Press –START-
Push –START- to go
regulation
PHASE
Password "100"
Modify parameters with P1 and P2
Modify with P1 and P2
Modify with P1 and P2
Modify with P1 and P2
Modify with P1 and P2
Modify with P1 and P2
out from
DISPLAY
P A n
P A S
100
Value
P A n
C L O
input day
input month
input year
input hour
input minutes
27
DAQF028_rev0.10