Machine Status - Tecno-gaz DAQF028 REV0.10 Mode D'emploi

TECNO-GAZ
KEYS SEQUENCE FOR PRINTING HISTORICAL DATAS:
Press -PRG- for 5 seconds
Press -PRG-
Press -PRG-
Press –START-
KEYS SEQUENCE TO DELETE ALL HISTORICAL EVENTS:
Press -PRG- for 5 seconds
Press -PRG-
Press -PRG-
Press -PRG-
Press - START-
Press - P1 -
Press -START-
Press -P 1-
Press –START-

5. MACHINE STATUS

When there is a voltage drop in the line and the tension is restored, the machine memorises the status that was present at the time of
the voltage drop. When the tension is restored the machine normally returns to "wait" mode.
5.1 WAIT:
The machine is ready to start a cycle.
The diagnostics are active.
5.2 CYCLE:
Cycle mode is entered by pressing the Start switch, this command is only accepted if the machine is in wait mode and the door
is closed.
The cycle carries out the foreseen stages. The diagnostics and regulators are active. The user interface gives information concerning
the stage in progress.
5.3 SHUTDOWN:
The diagnostics have detected a fault that causes the machine to shutdown, the cycle is suspended and the door remains
locked. The fault is indicated on the red led and the user interface is ready for the door release sequence and the Reset
procedure to restore the machine to Wait (see reset procedure).
ALL MEMORIZED CYCLES
PRINTING
Insert Password "50"
STARTING IN DELETING HISTORICAL
EVENTS.
AFTER THIS OPERATION,
MEMORIZED CYCLES ARE DELETED
Password "100"
Modify parameters with P1 and P2
28
P A n
C L O
P r n
ARE AUTOMATIC EXIT
PROGRAMMING PHASE
P A n
C L O
P r n
E r a
P A S
50
ALL
100
Value
DAQF028_rev0.10
FROM