Publicité
Problem description
The lamp is turned off.
Trouble with wireless network sig‐
nal.
New router installed or router con‐
figuration changed.
The wireless network signal is
weak.
The wireless signal is disrupted by
microwave oven placed near the
appliance.
12.2 Error codes
When the software error occurs, the display shows error message. You will find the list of
problems in the table below.
Code and description
F102 - the door is not fully closed or the door lock is
1)
broken.
F111 - Food Sensor is not correctly inserted into the
socket.
F240, F239 - the touch fields on the display do not
work properly.
F908 - the appliance system cannot connect with the
control panel.
F131 - the temperature of magnetron sensor is too
1)2)
high.
F602, F603 - Wi-Fi is not available.
1)
When the following error message continues to appear on the display, it means a faulty subsystem may have
been disabled. In such a case contact your dealer or an Authorized Service Centre.
2)
If one of these errors occurs, the rest of the appliance functions will continue to work as usual.
12.3 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is located
on the front frame of the appliance. It is
visible when you open the door. Do not
remove the rating plate from the appliance.
22
ENGLISH
Cause and remedy
The lamp is burnt out. Replace the lamp.
For details refer to "Care and Cleaning" chapter.
Check if your mobile device is connected to the wireless network. Check
your wireless network and router.
Restart the router.
To configure appliance and mobile device again, refer to "Before first use"
chapter, Wireless connection.
Move router as close to the appliance as possible.
Turn off the microwave oven.
Avoid using microwave oven and the Remote operation of the appliance at
the same time. Microwaves disrupt WiFi signal.
Remedy
Close the door.
Turn the appliance off and on.
Fully plug Food Sensor into the socket.
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
Turn the appliance off and on.
Turn the appliance off and wait until it cools down. Turn
the appliance on again.
1)2)
Turn the appliance off and on.
We recommend that you write the data
here:
Model (MOD.) :
Product number (PNC):
Serial number (S.N.):
Publicité
