Publicité
3x
CLEANING&MAINTENANCE
1. Descaling process
This appliance is equipped with an automatic clean warning indicator, which indicates
that scale particles must be removed from inside the steam chamber. When activated,
three beeps will be heard and the "Calc'nClean" indicator light (1) will flash, indicating
that the process should be performed.
3x
You may continue ironing for a time. Once this time has passed, you will only be able to
dry iron (without steam).
To start steam ironing again, follow this descaling process:
1 Fill the tank (7) with water.
2 Plug in the mains cable (5) and press the button (2) to switch the appliance on.
3 Press the descaling button (1) for 2 seconds. Its indicator light will remain permanently
lit.
4 Wait until the indicator light (2) stops flashing and remains lit permanently. Two beeps
will be heard.
5 Place the iron on the "Calc'nClean" container (14). Make sure that the surface on which
the container is placed is stable.
2"
2x
Avisos:
Warnings:
• Do not remove the iron from the container until the process has finished. Boiling water
and steam will be released through the soleplate, removing limescale and/or deposits
that may be inside.
• The container must only be used to perform the descaling process. It must not be used
as a stand for the iron while ironing.
6 Press the steam release button (12) for 2 seconds. The descaling process will start auto-
matically. During this process, short beeps will be heard.
7 After approximately 3 minutes, the iron will stop releasing steam. A long beep will be
26
Publicité
