Publicité
Note: Take care to match the RED/WHITE plugs to the corresponding RED/WHITE sockets.
Connect the other end of the cable to an AUDIO INPUT on the amplifier (check your amplifier
user manual if you are not sure).
The volume control on the turntable will have no effect on the volume level when connected
this way. All volume controls should be operated from the amplifier.
Note: Turn the volume on the turntable all the way down, so it does not interfere with the
external sound system.
PLAYING A RECORD
（Turn the BT OUT button on OFF position）
Before use, ensure the security wire (tone-arm rest/lock) and the cartridge protector
(stylus/cartridge) have been removed. And the tone-arm lock is released.
Place a record on the turntable platter (1).
Select the speed required using the speed selector switch (6).
Raise the tone-arm (5) using the tone-arm lift lever (7). As you move the tone-arm towards the
record the turntable begins spinning. Lower the needle gently onto the outer edge of the record
using the tone-arm lift lever (7).
Rotate the ON/OFF/Volume control knob (8) to increase or decrease the volume level.
When the record has finished playing the tone-arm will raise and return to the rest position.
Some of vinyl need to push "Auto-OFF" to finish playing.
USB FLASH DRIVE AND MEMORY CARD READER RECORDING
(Lift up the tone arm and put it on the rest, Turn the BT OUT button on OFF position)
LISTEN TO MUSIC:
If you want to play or pause music from your installed memory card or USB flash memory, turn
the power & volume control knob clockwise to power on; the music will start playing
automatically.
You can play or pause music by pressing the play-pause/del button.
If you want to play the next or previous track from your installed memory card or USB flash
memory, press the next track or previous track button.
If you have installed a memory card & USB flash memory, the last one installed will start playing.
You can select the desired source by pushing the MODE/REC button. (SD => USB). The mode
button will select the active/installed sources only. Only mp3 file format is supported.
Note: the tone arm must be in rest position.
RECORDING MUSIC:
You can convert your vinyl records into digital mp3 files by inserting an memory card in the memory
card reader slot or USB flash memory device into the USB port.
Play your 'vinyl' music, as described in 'listening to a record'.
Press and hold the MODE/REC button for 2 seconds.
20
Publicité
