Publicité
approximately 10 seconds after releasing the switch
trigger.
With the lamp status OFF, the lamp does not turn on
even if pulling the trigger.
► Fig.4: 1. Lamp
► Fig.5: 1. Button
NOTE: To confirm the lamp status, pull the trigger.
When the lamp lights up by pulling the switch trigger,
the lamp status is ON. When the lamp does not come
on, the lamp status is OFF.
NOTE: When the tool is overheated, the light flashes
for one minute, and then the LED display goes off. In
this case, cool down the tool before operating again.
NOTE: Use a dry cloth to wipe the dirt off the lens
of the lamp. Be careful not to scratch the lens of the
lamp, or it may lower the illumination.
NOTE: While pulling the switch trigger, the lamp
status cannot be changed.
NOTE: For approximately 10 seconds after releasing
the switch trigger, the lamp status can be changed.
Changing the operation mode
This tool has multiple operation modes: 4 steps of impact mode and 3 steps of auto-stop mode. Select an appropri-
ate mode according to your work.
You can change the operation mode within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the operation mode approximately one minute if you press the but-
ton
or
.
Changing the impact mode
You can change the impact force in four steps: 4 (max), 3 (hard), 2 (medium), and 1 (soft).
The level of the impact force changes every time you press the button
► Fig.7
Operation mode
(Impact force grade displayed
on panel)
4 (Max)
3 (Hard)
2 (Medium)
1 (Soft)
: The lamp is on.
Maximum blows (min
TW001G
TW002G
2,500
2,400
2,400
2,000
2,200
1,800
1,900
1,700
9 ENGLISH
Reversing switch action
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
► Fig.6: 1. Reversing switch lever
.
-1
(/min))
TW003G
2,400
2,300
2,000
1,600
Purpose
Tightening when the force and the
speed are desired.
Tightening with less force and
speed than Max mode (easier to
control than Max mode).
Tightening with less force to avoid
screw thread breakage.
Tightening when you need fine
adjustment with small diameter
bolts.
Publicité
