Publicité
Auto-stop mode
Auto-stop mode helps for good control when driving bolts.
This mode has 3 steps. It also works differently for clockwise and counterclockwise rotation.
Main purpose
•
Clockwise: Reduce the risk of breakage of bolts/nuts due to overtightening.
•
Counterclockwise: Prevent a bolt from falling off. When loosening a bolt, the tool automatically stops or slows
down after the bolt/nut has been loosened enough.
The type of the auto-stop mode changes every time you press the button
NOTE: The timing to stop the driving varies depending on the type of the bolt/nut and material to be driven. Make a
test driving before using this mode.
NOTE: This mode works only when the switch trigger is fully pulled.
NOTE: The impact force is the same as impact mode 4 in auto-stop mode.
► Fig.8
Auto-stop mode
(Auto-stop mode displayed
on panel)
1
2
3
: The lamp is on.
Full speed mode
When full speed mode is turned on, the tool speed
becomes fastest of the selected operation mode even if
you do not pull the switch trigger fully. When full speed
mode is turned off, the tool speed increases as you
increase the pressure on the switch trigger.
To turn on full speed mode, press and hold the but-
ton
. To turn off full speed mode, press and hold the
button
again.
The lamp turns on while full speed mode is on.
► Fig.9: 1. Button
NOTE: Full speed mode continues even after switch-
ing the operation mode.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
The tool stops automatically as soon as the tool has
started impact blows.
This mode helps to repeat screwdriving continuously with
equal torque. This mode also helps to reduce the risk of
breakage of bolts/nuts due to overtightening.
The tool stops automatically approximately 0.5 second
later from the moment that the tool has started impact
blows.
The tool stops automatically approximately 1 second later
from the moment that the tool has started impact blows.
2. Lamp
Feature
Clockwise
Selecting correct impact socket
Always use the correct size impact socket for bolts and
nuts. An incorrect size impact socket will result in inac-
curate and inconsistent fastening torque and/or damage
to the bolt or nut.
Installing or removing impact socket
CAUTION:
and the mounting portion are not damaged before
installing the impact socket.
CAUTION:
make sure that it is firmly secured. If it comes out,
do not use it.
Tool with the ring spring
For impact socket with O-ring and pin
Only for model TW001G
Move the O-ring out of the groove in the impact socket
and remove the pin from the impact socket. Fit the impact
socket onto the square drive so that the hole in the impact
socket is aligned with the hole in the square drive.
Insert the pin through the hole in the impact socket
and square drive. Then return the O-ring to the original
10 ENGLISH
.
Counterclockwise
The tool stops automatically as soon
as it has stopped impact blows.
The tool stops automatically approx-
imately 0.2 second later from the
moment that the tool has stopped
impact blows.
The tool slows down the rotation after
the tool has stopped impact blows.
Make sure that the impact socket
After inserting the impact socket,
Publicité
