Publicité
Press the button a fourth time and the swivel function switches on. The display
continues to show Fig. C.
Press the button a fifth time and the unit returns to standby (S). The unit will cool down
for 5 minutes.
You can set a delayed start time using the timer button
and press the timer button. Each time you press the timer button, one hour is added to
the start time. The display shows the number of hours set and counts down at the end
of each hour. The timer lamp also switches on. The unit starts automatically at the end
of the set time. The standard temperature is 23°C (note it is not possible to set the
thermostat using the buttons).
If the weekly programme is not set and if no temperature has been set using the
remote control, the unit will switch off automatically after 12 hours.
Operation using the remote control
Please note: the remote control only works if the emitter on the remote
control can make contact with the receiver on the unit.
Make sure that the unit is in standby mode (S) (use the main switch).
Press the power button
will show Fig. A.
Press the function button
The display will show Fig. B.
Press the button again and the heating will switch to full power. The
display will show Fig. C.
Press the function button a third time and the unit will return to
mode A.
If you press the swivel button
move up and down, changing the direction of the air. Press the swivel button again to
turn this function off.
The timer button
on the unit.
Set the day and time:
Make sure that the unit is in standby mode (S) (use the main switch).
You can also set the day and time while the unit is switched on.
Press the SET button
plus and minus buttons
SE T again to see the minutes. The display shows "30" and you can use
the plus and minus buttons to set the number of minutes, from 00 to
59.
Press SET again and the display will show
buttons to set the day: Monday = d1, Tuesday = d2, etc.
Finally, press
mode it was in before you set the day and time. Press SET to check the day and time.
to switch the ventilator on; the display
to switch the heating on, on low power.
while one of the three functions is set, the flap will
on the remote control works in the same way as the timer button
once; the display now shows "12". Use the
/
to set the hour (from 1 to 23). Press
to confirm the settings. The display will return to the
; use the plus and minus
36
. Set the unit to standby (S)
Publicité
