Publicité
The device has to be hung from a wall and therefore may not be used in a lying,
leaning, hanging or standing position! The wall on which the device is hung has to be
firm, flat and perfectly vertical and made from non-inflammable material that cannot
melt. It has to be at least 20 cm away from side walls and the top has to be at least 180
cm above the floor.
The heater has to preferably be positioned at and permanently connected to an electric
socket. This connection may only be made by a qualified electrician and, for that
reason, is not described here. In this manual, for reasons of safety, use with a plug
should be assumed; when there is a permanent connection, any passages about the
plug do not apply.
Drill two holes in the wall at the required locations, to fit the plugs exactly: make sure
these holes are horizontal and 39.4 cm apart. Insert plugs and screws into the holes.
Allow the screws to stick out by 10 mm. Hook the heater over the screws using the
hanging eyes, then slide to the left and pull downwards. The fixing material supplied is
suitable for brick walls. Consult a specialist, for instance at a DIY store, if your wall is
built of other material.
Check whether the heater is secured to the wall; if
necessary insert the screws a little further into the plugs.
Attach the heater using the materials supplied. Place the
bracket on top of the heater (see picture) with the short
side against the wall. Mark the location of the hole on the
wall and remove the heater. Drill a hole at the marked spot
and insert a plug. Now hang the heater in place and screw
the bracket to the wall, as shown in the diagram. The
heater is now installed.
Using for the first time and operation
Make sure that the main switch is OFF (O)
Unroll the electrical cable entirely and insert the plug into a suitable
220/240V socket.
Set the main switch to ON (l). The display will show "S" (standby).
Manual operation using the buttons
Press the F button once. The ventilator will
switch on and the display will show Fig. A.
Press the button again and the heating will
switch on, on low power. The display will show
Fig. B.
Press the button a third time and the heating
will switch to full power. The display will show
Fig. C.
35
Publicité
