Publicité
bottom hinge screws and feet. Ensure the appliance will not slip or move.
6. Remove the bottom hinge screws (7) and hinge bracket (6) on the right side.
7. Remove top hinge cover (2) and bottom foot (8) on the left side.
8. Fit top hinge cover (2) and bottom foot (8) on the right side.
9. Fit bottom hinge bracket (6) on the left side.
10. Carefully bring chiller back to the upright position.
11. Place glass door onto bottom hinge bracket and hold in place.
12. Fit top hinge bracket (4) on the left side, carefully checking the door alignment.
13. Fit top hinge cover (2) on the left side.
IMPORTANT: After changing the door direction check the door is aligned horizontally and
vertically and that the seals are closed on all sides before fully tightening the top hinge. Adjust
the levelling feet to minimize operating noises caused by vibration.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30
minutes before switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing foods in your appliance, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it to reach the correct temperature.
4. USE INSTRUCTIONS
Temperature setting:
Your refrigerator has one control for regulating the temperature. The temperature control is
located at the top of the fridge.
The first time you put your appliance into operation, set the thermostat to "3" and let it run
empty for 4 hours before storing food for it to cool sufficiently.
The range of the temperature control is from position "1" the warmest to "6" the coldest.
Appliance thermostat has 6 settings. The appliance assures that temperature is maintained
as long as it is in operation and that it is used in normal conditions of use. The temperature
24
Publicité
