Publicité
each of the two clamps (a). Then place the red safety strap around the frame
and secure it with the push button (b).
Fig. 7:
The push bar height can be adjusted by pressing the two adjustment joints
(12).
Use as a sports stroller:
Fig. 8.:
Place the footboard on the lower crossbar of the frame and optionally secure
it in this position with the Velcro at the narrow end on the back around the
frame tubes. You can bring the footboard into a horizontal position by tilting
it. To hold it in this position, you can insert the bracket located on the underside
into the holder provided.
Fig. 9.:
The seat cover is connected to the frame with four piping straps. First insert
these from above into the openings (a) located on the height adjustment of
the push bar and repeat the step with the piping straps below the folding joint
(b).
Fig 10.:
Then guide the straps in the head area of the seat cover through the loop on
the height adjustment and fasten each with a press stud on the backrest (c).
Then close the two press studs under the seat (d) and the two pins (e) on the
footrest. In addition, the straps of the backrest adjustment (f) must be passed
through the opening in the seat cover and around the frame tube and closed
with the push buttons. Finally, close the two sports belt attachments (g) on the
left and right around the rear frame tube.
Fig. 11:
To adjust the position of the backrest, press the catch (14) on the back of the
seat back and swing it down. To bring the backrest into an upright position,
pull the straps of the locking device and push the backrest upwards.
Fig. 12:
Place the bumper bar on the frame tubes from above. Secure it by latching
the clamping levers (15) left and right. By pressing the buttons (16) you can
move it to different positions (e.g., fold it forwards if you want to fold the
trolley). If you release the bar from the frame on one side by only opening the
clamping lever (15), you can swing it to the side and make it easier for your
child to get in.
Publicité
