Publicité
PLEASE READ THESE ESSENTIAL INSTRUCTIONS
This machine is designed, developed and rigorously tested to function efficiently and safetly when properly
maintained and used in accordance with the following instructions. These instructions have been prepared
with safety and efficiency paramount.
The MACHINE OPERATOR must be trained by a suitably qualified instructor, and be made aware of the re-
levant reulations and legislation currently in force at the time of use.
CAUTION - This machine MUST NOT be used in explosive or inflammable atmospheres or where such
atmospheres are likely to be produced by the presence of volatile liquid or inflammable gas or vapour.
CAUTION - In no circumstances should the power supply cord be wrapped around fingers or any part of the
operators person.
CAUTION - The electrical supply plug must not be subjected to undue stress by pulling on the power supply
cord.
Your MACHINE must only be connected to an electrical supply of the same voltage and frequency indicated
on the rating plate. Ensure that the plug fitted to the end of the power supply cord is suitable for your supply
socket, if not refer to the information contained in 'Electrical Connections', or consult a qualified electrician.
The electrical installation from which the supply is drawn must be maintained to current Institute of Electrical
Engineers wiring regulations.
REGULAR SERVICING and INSPECTION of your machine must be carried out by suitably qualified
personnel in accordance with relevant legislation and regulations. In particular, electrical tests for earth
continuty, insulation resistance, and condition of the flexible cord should be checked frequently. In the event
of any defect the machine MUST be withdrawn from service, completely checked and repaired. Trained Ser-
vice Engineers will be pleased to carry out on site servicing on a regular or as requested basis, to ensure the
continuing safety and efficiency of your machine.
ELECTRICAL CONNECTIONS
IMPORTANT
240 volt 50 Hz. machines are fitted with a 13 amp. 3 pin moulded plug. If the availiable socket outlet is not
suitable for the plug supplied, the plug must be cut off and an appropriate plug fitted. The plug thus cut off
MUST BE DESTROYED for saftey reasons before being disposed of. Machines built for other voltages and
frequencies are not normally supplied with a fitted plug.If it is necessary to fit a plug, the wires in this power
supply cord are coloured in accordance with the
following code:
For double insulated machines
To connect the new plug:
If using a three-pin plug, do not make any connection to
the terminal in the plug which is marked with the letter 'E'
or by the safety earth symbol
green and yellow. This machine is double-insulated and
no earth connection is necessary.
The wire which is coloured blue must be connected to the
terminal in the plug which is marked with the letter 'N' or
is coloured black or blue. The wire which is coloured
brown must be connected to the terminal in the plug
which is marked with the letter 'L' or is coloured red or
brown. If the plug to be fitted does not conform to the
above notation then consult a qualified electrician.
For earthed machine
To connect the new plug:
The wire which is colored green & yellow must be
connected to the terminal in the plug which is marked with
the letter 'E' or by the safety earth symbol
green or green & yellow. The wire which is coloured blue
must be connected to the terminal in the plug which is mar-
ked with the letter 'N' or is coloured black or blue.
The wire which is coloured brown must be connected
to the terminal in the plug marked with the letter 'L' or is
coloured red or brown.If the plug to be fitted does not
conform to the above notation then consult a qualified
electrician.
, or colored green or
or coloured
(Only applicable for UK.)
BLUE - NEUTRAL
BROWN - LIVE
BLUE
GREEN & YELLOW
GREEN & YELLOW- EARTH
BLUE - NEUTRAL
BROWN - LIVE
FUSE
BROWN
CORD CLAMP
FUSE
BROWN
BLUE
CORD CLAMP
17
Publicité
