Connecting / Disconnecting Belt Clip; Paging Parent Unit - Philips SCD487 Mode D'emploi

Other features
EN
12

Connecting / disconnecting belt clip

If the parent unit is operating on batteries, you can carry it in
and around your house, giving you freedom of movement while
still monitoring your baby.
Connect
• Insert the little spindle on the rear of the belt clip into the
recess (B-11) on the rear of the parent unit.Turn the belt clip
to the left until it clicks in position.
Disconnect
• Turn the belt clip to the right (TURN 2) and take it off.

Paging parent unit

When the parent unit is misplaced and the volume is switched
off, you can use the PAGE button (A-6) on the baby unit to
locate the parent unit.
1 Briefly press the PAGE button (A-6) on the baby unit.
> A paging alert will sound on the parent unit.
2 To stop the paging alert, briefly press the page button (A-6)
again or any button on the parent unit.
Note: If you press the PAGE button (A-6) too long, the paging
alert will not sound.