Switching The Link Alarm On And Off - Philips SCD463 Mode D'emploi

Switching the LINK alarm on and off

You can switch on the LINK alarm on the parent unit.The LINK
alarm will beep when connection between the units is lost.
1 Open the parent unit's battery compartment (B-10) by sliding
down the cover.
2 Set the switch (B-6) inside the compartment (B-10) to the
ON ( ) position.
3 Slide the battery compartment cover (B-10) back in place
until it clicks in position.
• To switch off the alarm, set the switch (B-6) to the
OFF ( ) position.
Other features
EN
11