Publicité
Setting the Clock
Changing the MW Channel Step
1
2
2,3
The MW channel step is factory-set to 9 (10) kHz to match the fre¬
quency allocation system of the country. It" you use the radio where the
frequency allocation system is based on 10 (9) kHz interval, set the
MW CH STEP 9/10 kHz selector in the battery compartment to 10 (9)
kHz.
1 Set POWER/LOCK to POWER.
When you first install batteries or the clock is reset, "0:00" flashes in
the display. Press TIME SET.
2
While holding down TIME SET, press a MANUAL TUNE/
SCAN START/STANDBY TIME SET/TIME SET button
to adjust
the clock.
Every pressing of an inner MANUAL TUNE/SCAN START/
STANDBY TIME SET/TIME SET button (O or O) changes the time
setting by one minute, and an outer button (Kb or Oi) by one hour.
To advance the time digits rapidly, keep it pressed.
3
Release TIME SET.
The " : " indication starts flashing, and the clock begins to operate.
While listening to the radio
The display when POWER/LOCK is
You cannot set the clock while you are
LOCK
listening to the radio. Be sure to press
The current time is displayed.
ON/OFF to turn the radio off and then
set the clock.
1 Set POWER/LOCK to LOCK.
2
Open the battery compartment and remove the batteries.
3
Change MW CH STEP 9/10 kHz.
4
Install the batteries and dose the battery compartment.
5
Set POWER/LOCK to POWER.
The frequency allocation of the area
Area
Frequency allocation
system
North America,
South America
10 kHz step
Other countries
9 kHz step
Change the MW CH STEP 9/10 kHz
within 10 minutes
If more than 10 minutes have passed
after the batteries were removed, the
current time will be erased. In this case,
set the time again.
12
13
Publicité
