Publicité
1 Tune in the desired station which you want to listen to at
the desired time
by way of direct tuning (see page 14), manual
tuning (see page 16), scan tuning (see page 18) or preset tuning (see
page 20).
2 Adjust VOLUME.
3 While keeping ENTER pressed, press STANDBY MEMORY/
TIMER STANDBY/STANDBY TIME SET
[a]
or
®. The station is
preset on that button.
STANDBY MEMORY
TIMER STANDBY/
ENTER
STANDBY TIME SET
4 Press ON/OFF.
The radio will be turned off.
5 While keeping STANDBY MEMORY/TIMER STANDBY/
STANDBY TIME SET
[a]
or
[b]
pressed, press a MANUAL
TUNE/SCAN START/STANDBY TIME SET/TIME SET to set the
standby time.
Every pressing of an inner MANUAL TUNE/SCAN START/
STANDBY TIME SET/TIME SET button
(O
or 5>) changes the
standby time by one minute, and an outer button (i<b or <x) by one
hour. To advance the time digits rapidly, keep it pressed.
The STANDBY
fal/fbl
indicator flashes in the display while
STANDBY MEMORY/TIMER STANDBY/STANDBY TIME SET [a]
or
[b]
is being pressed.
STANDBY MEMORY
Ex. Setting 7:15 to STANDBY ®
6 Stop pressing STANDBY MEMORY/TIMER STANDBY/
STANDBY TIME SET
[a]
or
[b].
The current time appears in the
display, and the STANDBY
[a]/®
indicator will continue to be
displayed.
When you set the standby time
Be sure to turn the radio off. You cannot
set the standby time while you are
listening to the radio.
To cancel the standby mode
Press STANDBY MEMORY/TIMER
STANDBY/STANDBY TIME SET [a] or
[0 so that the STANDBY @/[E
indicator disappears or set POWER/
LOCK to LOCK.
Once you preset the standby time
The radio is turned on at the same time
everyday.
To check the preset standby time
Hold down STANDBY MEMORY/
TIMER STANDBY/STANDBY TIME
SET S3 or H when the STANDBY ®/
lb!
indicator is not displayed.
To change the preset standby time
Set the desired standby time. The time
previously set is erased.
When the radio is turned on at the
preset time
The radio will be turned off
automatically after about 60 minutes.
When you are listening to the radio at
the preset time
The frequency will change to that preset
to the appropriate STANDBY
MEMORY/TIMER STANDBY/
STANDBY TIME SET button.
You can set standby [a] and
\b\
together
When the standby time comes while the
other standby is working, the next
standby will work with the appropriate
frequency.
If you set standby [a] and [b] to the
same desired time
Only standby [a] will work.
24
25
Publicité
