During Cooking - all-clad PC8-PRECISION Guide De L'utilisateur

• Also check that the safety valve (M) can move: see
Fig. 18
and refer to the "Cleaning and Maintenance"
heading.
• Add your ingredients and the liquid.
• Close the PC8-PRECISION.
• Move the selector to one of the programs as shown
in your recipe book.
• Program the Smart Timer
shown for your recipe.
• Place the PC8-PRECISION on a heat source set to
full power.
Just like for any other
cooking appliance, always
pay close attention to it,
especially when using
PC8-PRECISION near
children.
The steam jet coming
from the steam release
outlet (A) is very hot.
The pressure indicator (D)
prevents pressure from
rising in the pressure
cooker if it is not properly
closed.
Finishing cooking
• At the end of the cooking time at low pressure,
the third acoustic signal emitted by the timer
indicates that cooking has ended.
• Check that the pressure indicator (D) has
dropped back down.
• Raise the Open/Close handle to the vertical
position to open the lid.
10
Fig. 9
®
for the cooking time
Fig. 10
• The first audible signal, tells you to reduce the
heat.
PC8-PRECISION steam cooking with pressure
starts and the Smart Timer
• At the end of the pressure cooking stage, on the
second acoustic signal, the timer tells you to switch
off the heat and set the cooking program selector
to PRESSURE RELEASE.
• A jet of hot steam, and possibly droplets of water,
escapes from the steam outlet (A) in a vertical
direction.
The soft cooking phase starts (this time is ready
programmed).
• If you accidentally open your PC8-PRECISION
during the soft cooking phase, close it back up
immediately, and this will have no effect on
cooking.
• Never remove the Smart Timer
pressure cooking or soft pressure cooking phases.
Fig. 1
Always position the
PC8-PRECISION
so that the program
selector (F) faces you.

During cooking

®
counts down.
Fig. 8
®
during the
To move
PC8-PRECISION, use
the carrying handles on
the side of the cooker.
The pressure indicator
(D) prevents the pressure
cooker from being
opened if it is still under
pressure.