all-clad PC8-PRECISION Guide De L'utilisateur page 16

Never wash the gasket in the dishwasher.
To clean the control panel
and the valves
• Remove the control panel from the lid and remove
the Smart Timer
• Remove the Smart Timer
• Wash the panel under a gentle flow of running water.
• Visually check that the steam release outlet (A) is
not blocked by seeing light through it as shown in
Fig. 16
. If it is blocked, clean it under running water.
Refit the control panel.
• Check that the operating valve (L) located inside the
lid is mobile, by moving the program selector to
"Prog 1" and pressing with a finger:
only do this when the panel is fitted on the lid!
• You can clean this valve under running tap water.
• Also check that the safety valve (M) works properly
by using a cotton swab (for example) to press down
hard on the center of the pipe, a part that should
Fig. 18
move: see
running tap water.
• Check that the steam release outlet gasket (K) is in
place. If this gasket is missing or has been damaged,
leaks may appear under the panel when your
PC8-PRECISION is in use. The shape of the gasket
lets you easily remove and refit it. If necessary, you
can get replacement seals from an All-Clad approved
service center.
• Check that the pressure indicator (D) is clean. It can
be cleaned under running tap water.
12
®
: see the "Control panel" heading.
®
.
. You can clean this valve under
To clean the lid gasket
• After using the PC8-PRECISION,
always clean the gasket (H) and its
groove.
• Wash the gasket using a sponge
and dishwashing liquid.
• To refit the lid gasket, refer to the
drawing
words "face côté couvercle" (side
facing the lid) are against the lid.
Fig. 17
. You can
Fig. 15
and ensure that the
Never dismantle the
control panel.
Don't forget to
remove the Smart
®
Timer before
cleaning the control
panel by hand or in
the dishwasher.
Never use a cutting or
pointed object to
clean the safetly valve
(M).