all-clad PC8-PRECISION Guide De L'utilisateur page 20

Problems
If steam escapes from
around the lid together
with a piercing noise,
check:
If you cannot open the
lid:
If food is not cooked or
has burnt, check:
If food has burnt in the
PC8-PRECISION:
If one of the safety
systems is triggered:
If the decompression
valve (O) is
disassembled:
Environment protection first!
i
‹
16
That the gasket is not caught between the body and
the lid.
Check that the selector is set to PRESSURE
RELEASE.
Check that the pressure indicator is down.
If not, release pressure by moving the program
selector to PRESSURE RELEASE
Never tamper with this pressure indicator.
The cooking time is correct.
The heat level was either too low or too high.
That the cooking program selector was in the right
position.
The amount of liquid was sufficient for the cooking
time.
Fill
PC8-PRECISION to soak for a while before
washing.
Never use bleach or chlorine products.
Turn off the heat.
moving it or turning the program selector (F) to the
Leave PC8-PRECISION to cool down without
steam release positon and do not open it until it has
completely cooled.
Check and clean the operating valve, the steam
release outlet, the safety valve and the gasket.
If the fault persists, have your PC8-PRECISION
inspected by an All-Clad approved service center.
Have your PC8-PRECISION inspected by an
All-Clad approved service center.
Your appliance contains valuable materials which can be
recovered or recycled.
Leave it at a local civic waste collection point
Recommendations
the pot with
Fig. 8
water and leave
.
the