all-clad PC8-PRECISION Guide De L'utilisateur page 19

All-Clad answers your questions
Problems
If you cannot close the
lid:
If the PC8-
PRECISION has heated
up under pressure with
no liquid inside:
If the pressure indicator
did not rise and nothing
escapes from the valve
during cooking:
If the pressure indicator
has risen but still nothing
escapes from the valve
during cooking:
If steam escapes from
around the lid, check:
Recommendations
Check that the Open/Close handle is in the vertical
position.
Check that the gasket is fitted correctly, see the
"Cleaning and Maintenance" heading.
Have your PC8-PRECISION inspected by an
All-Clad approved service center
Check that:
- The cooking program selector is set to one of the
cooking programs.
- Your PC8-PRECISION is properly closed.
This is normal for the first few minutes.
If the problem persists, select the PRESSURE
RELEASE program. Wait for the pressure indicator
to drop then move the Open/Close handle to the
vertical position.
Clean the operating valve and steam release outlet
under running water and check that the safety valve
Fig. 17
moves: . See the "Cleaning and Maintenance"
heading.
- That the lid is properly closed.
- The position of the lid gasket is correctly fitted.
- That the gasket is in good condition, and if
necessary, replace it by contacting an All-Clad
approved service center.
- That the lid, the gasket, and its surrounding area
are clean.
That the edge of the PC8-PRECISION pot is in
good condition.
EN
15