Before First Use; Before Cooking - all-clad PC8-PRECISION Guide De L'utilisateur

Before First use

• Put the trivet (P) under the steaming basket (I).
• Place the steaming basket in the PC8-PRECISION.
• Fill the PC8-PRECISION to the two-thirds mark
(the maximum mark) with cold water.
• Close the PC8-PRECISION.
• Move the pressure selector to "prog 4".
• Set the Smart Timer
• Place the PC8-PRECISION on a heat source set to
full power.
• When the Smart Timer
the heat to low so there is a constant, yet gentle &
steady release of steam.
The steam cooking with pressure phase starts.
• Once the steam cooking phase is finished, the Smart
®
Timer beeps indicating to turn off the heat and
move the program selector (F) to PRESSURE
Fig. 8
RELEASE -
• Hot steam, and possibly droplets of water, escape from
the steam outlet (A) in a vertical direction.
The soft cooking phase starts (this time is already
programmed).
• When the soft cooking phase is finished, the Smart
Timer beeps indicating that cooking is finished
stop beeping, simultaneously press the + and - buttons.
• Check that the pressure indicator (D) has dropped
back down.
• Raise the Open/Close handle to the vertical position
Fig. 1
to open the lid.
• Remove the Smart Timer
Using PC8-PRECISION
PC8-PRECISION.

Before cooking

• Every time you use your PC8-PRECISION, first
check that the control panel is correctly fitted and
tightened (using a coin) and check that the operating
valve (L) located inside the lid can move, by moving
the program selector (F) to "prog 1" and pressing the
valve with your finger.
®
for 20 minutes.
®
beeps, this indicates to turn
Fig. 12
®
, wash and dry the
Fig. 17
Always position the
PC8-PRECISION
so that the selector
faces you.
Open my
PC8-PRECISION
Never force the
pressure cooker open,
make sure the pressure
. To
indicator is down in
the normal position.
decompression valve
EN
®
9